My questions concerns the diameters of the two holes in caps to vent fuel tank.
the vent holes in my existing caps are 7/64th inch each.
Is this the correct diameter of vent holes?
If not, what might be minimum diameter for vent holes?
Gas caps
Forum rules
You must be a member of the Cessna 120-140 Association in order to post new topics, reply to existing topics, or search for information on this forum. Use the "Join" link in the red menu bar.
You must be a member of the Cessna 120-140 Association in order to post new topics, reply to existing topics, or search for information on this forum. Use the "Join" link in the red menu bar.
-
- Posts: 33
- Joined: Tue May 01, 2018 7:00 am
- Name: Larry Benson
- Location: Grissom AFRB
- Aircraft Type: 120
- Occupation-Interests: Retired
- Contact:
- 6597
- Posts: 377
- Joined: Tue May 01, 2018 7:00 am
- Name: David Sbur
- Location: Vancouver WA KVUO
- Aircraft Type: '46 140 0-200A
- Occupation-Interests: Agriculture
- Contact:
Re: Gas caps
Neal's article on forward facing gascaps has a note early on that says "a little less than 1/8" for the two holers.
viewtopic.php?f=10&t=106
viewtopic.php?f=10&t=106
- 6643
- Posts: 2449
- Joined: Tue May 01, 2018 7:00 am
- Name: John C
- Location: KLCI, NH
- Aircraft Type: 1946 C140/C90
- Occupation-Interests: A&P, semi-retired
- Contact:
-
- Posts: 33
- Joined: Tue May 01, 2018 7:00 am
- Name: Larry Benson
- Location: Grissom AFRB
- Aircraft Type: 120
- Occupation-Interests: Retired
- Contact:
Re: Gas caps
Thanks for the input, very helpful.