Page 1 of 1
Elevator trim jack screw
Posted: Sun Oct 07, 2018 8:53 pm
by 1020
I am wondering if anyone has an exploded diagram or photos of the internal components and assembly sequence of the trim jack screw for a 140. If so, I would appreciate a P.M. to me at
nc73026@sbcglobal.net
Re: Elevator trim jack screw
Posted: Mon Oct 08, 2018 8:05 am
by 6643
There was an article in a news letter about 30 years ago...
Re: Elevator trim jack screw
Posted: Mon Oct 08, 2018 1:09 pm
by 6898
i'm looking in old newsletter articles if i find them i'll post for you
Re: Elevator trim jack screw
Posted: Mon Oct 08, 2018 3:17 pm
by 6643
6898 wrote: ↑Mon Oct 08, 2018 1:09 pm
i'm looking in old newsletter articles if i find them i'll post for you
I'm guessing is was back around 1990, but I could be off a few years either way...
Bill Rhoades may know; he probably wrote it...
It's probably in the back of my reference manual, but, unfortunately, that's out at the hangar.
Re: Elevator trim jack screw
Posted: Mon Oct 08, 2018 3:53 pm
by 6643
OK, it's Technical Advisor #81 and it makes reference to Cessna Service Bulletin SE-73-25.
If I knew your name.... But I'm not going to email someone I only know as 1020. (Don't take it personally!)