Page 1 of 1

to 6643

Posted: Tue Aug 06, 2019 2:24 pm
by 8431
are the skis federal 1500 and how wide are they ? Thank you

Re: to 6643

Posted: Tue Aug 06, 2019 3:51 pm
by 6643
Oh, 6643, I guess that's me...

They are A-1500's. The bottoms need to be replaced, but they are whatever width they were in 1946, maybe 6-7". I think most folks add about an inch on each side when they redo them. I''ll give you a call next time I'm headed up that way and we can get together and you can look them over. I think the axle adapters are from a Taylorcraft. You may be able to adapt them to the Cessna axles. Condition is a lot like this pair on ebay: https://www.ebay.com/p/Airplane-Aircraf ... 3156380391 Cables and bungies are shot and there are no adapters for the gear legs. Lots of parts are available from Aero-Ski. I was going to rebuild them "when I got a round tuit..." Ended up moving and selling the airstrip I was going to use them from. ;~(

Send me an email address by private message and I'll send you some photos.

Re: to 6643

Posted: Wed Aug 07, 2019 7:43 am
by 8431
Tried to send you my E mail would not go through.

Re: to 6643

Posted: Wed Aug 07, 2019 11:35 am
by 6643
8431 wrote: Wed Aug 07, 2019 7:43 am Tried to send you my E mail would not go through.
I don't think you have my email address...

Check your private messages (upper right, below the horizontal red stripe).