C140 Installation of Carb w/ Mixture Control

Ask Questions and Offer Advice Related to the Cessna 120 & 140 Type
Forum rules
You must be a member of the Cessna 120-140 Association in order to post new topics, reply to existing topics, or search for information on this forum. Use the "Join" link in the red menu bar.
Post Reply
harejac
Posts: 3
Joined: Fri Oct 25, 2024 3:55 am
Name:
Location: Savannah, GA
Aircraft Type: Cessna 140
Occupation-Interests:
Contact:

C140 Installation of Carb w/ Mixture Control

Post by harejac »

I'm a new C140 owner (1st airplane). My plane has a C-85-12 the Stromberg carburetor without any mixture control. Moving to a higher elevation area next year and will need a carburetor with mixture control for normal operations. Looking for suggestions on which carburetor is best to install with the C-85. Any information is greatly appreciated!
tonycondon
Posts: 88
Joined: Thu Oct 01, 2020 11:02 am
Name: Tony
Location: Wichita, KS
Aircraft Type: C-120
Occupation-Interests: Pilot, CFI, DPE
Contact:

Re: C140 Installation of Carb w/ Mixture Control

Post by tonycondon »

mixture control can be added to your stromberg. it is very likely that all the guts are there and the control is just wired full rich. if the guts are not there, they can be purchased from Fresno and installed by a competent mechanic or overhaul facility.

mine came without the guts, and eventually required overhaul. at overhaul i had the shop add the mixture control, and i used a mixture knob from McFarlane. Works nice.
N2395N
harejac
Posts: 3
Joined: Fri Oct 25, 2024 3:55 am
Name:
Location: Savannah, GA
Aircraft Type: Cessna 140
Occupation-Interests:
Contact:

Re: C140 Installation of Carb w/ Mixture Control

Post by harejac »

Ran that by my mechanic and he told me that all my guts are there! Said he could install the mixture control no problem. Would you happen to know the exact parts you used?
User avatar
6643
Posts: 2461
Joined: Tue May 01, 2018 7:00 am
Name: John C
Location: KLCI, NH
Aircraft Type: 1946 C140/C90
Occupation-Interests: A&P, semi-retired
Contact:

Re: C140 Installation of Carb w/ Mixture Control

Post by 6643 »

Where are you moving to? The Stromberg mixture control is not necessary until you get to about 5000 feet. Below that the carb does a pretty good job without it.
harejac
Posts: 3
Joined: Fri Oct 25, 2024 3:55 am
Name:
Location: Savannah, GA
Aircraft Type: Cessna 140
Occupation-Interests:
Contact:

Re: C140 Installation of Carb w/ Mixture Control

Post by harejac »

6643 wrote: Mon Oct 28, 2024 5:17 pm Where are you moving to? The Stromberg mixture control is not necessary until you get to about 5000 feet. Below that the carb does a pretty good job without it.
I'm moving to El Paso, TX. Field elevation is 3,500ft at ISA.
6183
Posts: 354
Joined: Tue May 01, 2018 7:00 am
Name: Mike Smith
Location: Florida
Aircraft Type: 140A (2) 1949 & 1950
Occupation-Interests: Retired aerial power line patrol pilot for Gulf Power Co. CFIA, CFII, MEI
120-140 Assoc. Florida Rep. N9633A & N9688A
Contact:

Re: C140 Installation of Carb w/ Mixture Control

Post by 6183 »

If you haven’t already done so take a look at this Neal Wright article on the Stromberg carburetor mixture control useage.
viewtopic.php?p=608#p608
User avatar
6643
Posts: 2461
Joined: Tue May 01, 2018 7:00 am
Name: John C
Location: KLCI, NH
Aircraft Type: 1946 C140/C90
Occupation-Interests: A&P, semi-retired
Contact:

Re: C140 Installation of Carb w/ Mixture Control

Post by 6643 »

At 3500 feet I doubt you'll have a noticeable difference in performance between a Stromberg without a mixture control, one with, and a Marvel Schebler with mixture control. The farther you get above 5000 feet, you'll notice a gradual decrease in performance without the mixture control. The other two options operate differently but have similar performance.

Read the article by Neal Wright. It'll help set the proper expectations from the Stromberg.
Post Reply