140 ailerons
Forum rules
You must be a member of the Cessna 120-140 Association in order to post new topics, reply to existing topics, or search for information on this forum. Use the "Join" link in the red menu bar.
You must be a member of the Cessna 120-140 Association in order to post new topics, reply to existing topics, or search for information on this forum. Use the "Join" link in the red menu bar.
-
8167
- Posts: 3
- Joined: Tue May 01, 2018 7:00 am
- Name:
- Aircraft Type:
- Occupation-Interests:
- Contact:
140 ailerons
I have a 1946 140 serial number 9440. Are the aileron push rods bent or straight?
-
dcannon
- Posts: 62
- Joined: Sun Jan 08, 2023 6:20 pm
- Name: Dan Cannon
- Location: San Diego
- Aircraft Type: 1946 C120
- Occupation-Interests: Physiologist
- Contact:
Re: 140 ailerons
They do have a subtle bend. See page 19 in the IPC.
- Attachments
-
- Screenshot_20260506_182707_Drive.jpg (377.27 KiB) Viewed 207 times
-
V529
- Posts: 684
- Joined: Tue May 01, 2018 7:00 am
- Name: Victor G
- Location: Michigan
- Aircraft Type: C-120
- Occupation-Interests: Work on airplanes till the cows come home..........they're still out.
- Contact:
Re: 140 ailerons
They should be bent.
-
8167
- Posts: 3
- Joined: Tue May 01, 2018 7:00 am
- Name:
- Aircraft Type:
- Occupation-Interests:
- Contact:
Re: 140 ailerons
How much bend should there be and should they both be the same?
-
6597
- Posts: 520
- Joined: Tue May 01, 2018 7:00 am
- Name: David Sbur
- Location: Vancouver WA KVUO
- Aircraft Type: '46 140 0-200A
- Occupation-Interests: Agriculture
- Contact:
Re: 140 ailerons
The bends are the same, my bends are closer to the belcrank. I'd wild-ass guess maybe a 5 degree bend?
If you study the thing, you can see that the rod is trying to run the bearing attached to the bellcrank in a horizontal plane and the bearing at the aileron connection in a vertical plane. There has to be a bend somewhere as one attach point is higher than the other.
Without the bend, the rod/bearing attached to the bellcrank end might be rubbing against the bellcrank halves when it is in motion, just my best guess...
Not the best pic but you can just make out the bend that is closer to the bellcrank.
If you study the thing, you can see that the rod is trying to run the bearing attached to the bellcrank in a horizontal plane and the bearing at the aileron connection in a vertical plane. There has to be a bend somewhere as one attach point is higher than the other.
Without the bend, the rod/bearing attached to the bellcrank end might be rubbing against the bellcrank halves when it is in motion, just my best guess...
Not the best pic but you can just make out the bend that is closer to the bellcrank.
- aileronbellcrank.jpg (93.75 KiB) Viewed 79 times
-
6643
- Posts: 2724
- Joined: Tue May 01, 2018 7:00 am
- Name: John C
- Location: KLCI, NH
- Aircraft Type: 1946 C140/C90
- Occupation-Interests: A&P, semi-retired
- Contact:
Re: 140 ailerons
John Cooper
www.skyportservices.net
www.skyportservices.net